2014-2019 3.0L Ram EcoDiesel EGR Delete Kit

2014-2019 3.0L RAM EcoDiesel EGR Delete Kit

Improve the performance of your motor!

0017.png__PID:28a2079b-f6b5-4d39-95e1-33000c6766e7

How it Installation?

Installation instructions

0017 1.png__PID:6766e73e-27f9-42ba-b98a-b9c9c881d92e

Step 1 :

Pull both sides of the injector cover forcefully, remove the injector cover and foam pad, loosen the hose clamp, remove the bolt fixing the cooler, and remove the EGR pipe from the cooler side.

Step 2 :

Using the kit bolts, install the baffle part number G onto the valve cover port. If an additional pressure gauge is used, install the NPT threaded joint and gently push the lug along the side to remove the gasket from the EGR pipe on the cooler side.

0017 2.png__PID:27f9e2ba-b98a-49c9-8881-d92ed8253935

0017 3.png__PID:b98ab9c9-c881-492e-9825-3935a6ec94e3

Step 3 :

Open the coolant reservoir cap, then place the radiator drain plug under the front driver's side, position the EGR upstream pipe directly behind the removed EGR actuator, and remove the 2 bolts that connect the pipe to the EGR unit. Use the provided bolt part number I and factory gasket to install the turbine manifold plate.

Step 4 :

Use the 2 bolts on the turbine manifold, install the provided baffle/mounting plate using the same holes as the bolts, reuse the bolts, accompanying nuts and washers, and tighten the front coolant pipe to the stopper bracket.

0017 4.png__PID:c881d92e-d825-4935-a6ec-94e375d727e8

0017 5.png__PID:d8253935-a6ec-44e3-b5d7-27e851d28c02

Step 5 :

Remove the position of the lower coolant pipe from the hard pipe, use one of the provided hose clamps to secure the provided hose to the hard pipe, and reconnect the large electrical connector to the new bracket. Tie any remaining wiring to the bracket to ensure that it does not Damaged.

TruckTok 2014-2019 3.0L Dodge Ram 1500 EcoDiesel EGR Valve & Cooler Delete Kit

TruckTok 2014-2019 3.0L Dodge Ram 1500 EcoDiesel EGR Valve & Cooler Delete Kit

$72.99

Material: Aluminum,Stainless steel,Silicone.
Eliminates soot build-up and clogged EGR Valves.
Reduce the possibility of EGR valve failure and no need for regular clean/replace.
EGR removed and the temperature in the engine compartment area dropped.
Includes all of the plates and necessary hardware necessary to fully remove the EGR cooler from your vehicle.
Need custom ECU tuning in order to use this kit on your vehicle.
Fitment: 2014-2019 3.0L Dodge RAM 1500 Ecodiesel.
Instruction Manual page: Click This