How it Installation?
Installation instructions
Step 1 :
Firstly, remove the 6 factory sensors from the exhaust system and disconnect all electrical connections to safely remove thefactory parts.
Step 2 :
Starting from the rear of the truck, loosen the clamp that secures the exhaust assembly to the DPF, and then remove the assembly from the rubber isolator on the frame to free the exhaust pipe assembly. Note: lubricants can be used to make it easier to remove hangers from rubber isolators.
Step 3 :
Firstly, slide the # 1 front pipe over two crossbeams and connect it to the downpipe using factory fixtures and gaskets. Ensure that the hanger is located in the rubber isolator and loosely secure the pipes and clamps for future adjustments.
Step 4 :
Connect the # 3 pipeline to the exhaust pipe, place the # 2 extension pipe in the middle, and measure the gap between the two new pipelines # 1 and # 3. Considering the overlap at both ends, this will be the trimmed length of extension tube # 2.
Step 5 :
After your extension pipe is in place, check whether all pipe systems are aligned, and adjust the clamp before tightening all pipe clamps, and gradually move from the downpipe to the rear of the truck.
Step 6 :
1.Install the bracket. The M10 bolt will be screwed into the support bolt. Secure the transmission dipstick to the bracket using 1/4-20 bolts, nuts, and washers.
2.The bracket will hold the coolant hose connector in place.
Other Related products
Discover unique designs you'll need
EGR Delete Kit
2019-2023 6.7L Dodge RAM
EGR Delete kit
2019-2023 6.7L Dodge RAM
4" MUFFLER
RAM / Powerstroke / Duramax
4” DPF Delete pipe
2019-2023 6.7L Dodge RAM
5” DPF Delete pipe
2019-2023 6.7L Dodge RAM
