How it Installation?
Installation instructions
Step 1 :
Use pliers to remove the hose clamps connected to the ventilation hoses at both ends of the valve cover.
Step 2 :
1.Follow that same hose down and remove hose clamps that are down towards the turbo. Pull the hose out.
2.Note: If your truck is a 2019+, cut the factory hose near the compressor housing and install the provided plug.
Step 3 :
Press the provided plug into the lower hose connected tothe turbine inlet and secureit with a clamp.
Step 4 :
1.Install the filter onto the 90 degree bend provided in the kit and secure it with clamps.2.Install the connected filter onto the valve cover of the previously removed ventilation pipe.
Step 5 :
1.Use the newly provided coolant hose and hose adapter to connect the two coolant ports previously connected to the EGR cooler. Secure the hose with the provided hose clamp.
2.Replace the manifold bolts with the provided vertical bolts.
Step 6 :
1.Install the bracket. The M10 bolt will be screwed into the support bolt. Secure the transmission dipstick to the bracket using 1/4-20 bolts, nuts, and washers.
2.The bracket will hold the coolant hose connector in place.